1001 DMM with M-Modules

The Model 1001 Analog-to-Digital Converter M-Module contains sixteen independent single-ended input channels to a single 16-bit, 10 microsecond ADC core. Level accuracy exceeds 0.1 percent. Each input channel has programmable acquisition arming, timing, moving average filters, low-pass input filters and optical isolation . Four software-selectable input ranges support operation in +/-10 volt bipolar, 0-10 volt unipolar, +/-5 volt unipolar and 0-5 volt unipolar. All calibration data is stored internally in non-volatile memory. A local DSP provides signal routing, data acquisition control, range selection, measurement correction and level offset normalization.

Specifications
	Sixteen Single Ended analog inputs
	16-bit 10 microsecond sampling Analog to Digital converter
	Accuracy of 0.1%
	16 on-board active low-pass 2-pole input filters with a cut- frequency of 1KHz. No adjustment potentiometers
	Analog front end optically isolated
	On-board isolated power supply for analog front end..
	+/-10V Bipolar ( default), 0 10V Unipolar, +/-5V Bipolar, 0 to 5v Unipolar.
	Input range per channel is configurable
	Software programmable update rate up to 50 kSPS ( default)